Question 1.
The exhibit represents a simple routed network. Node 7 is a Windows 2000 Professional machine that establishes a TCP communication with Node 10, a Windows 2003 Server. The routers are Cisco 2500 series running IOS 11.2. While working at Node 10, you run a packet capture. Packets received by Node 10, and sent from Node 7 will reveal which of the following combination of source IP and source Physical addresses:

A. Source IP address 10.0.10.115, Source Physical address for Node 7
B. Source IP address 50.0.50.1, Source Physical address for Node 7
C. Source IP address for Router D'sInt E0, Source Physical address for Node 7
D. Source IP address 10.0.10.115, Source Physical address Router D'sInt E0
E. Source IP addresses forboth Nodes 7 and Router D's Int E0, Source Physical address for both 
    Nodes 7 and Router D's Int E0.

Answer: D

Question 2.
You have implemented an IPSec policy, using only AH. You are analyzing your network traffic in Network Monitor, which of the following statements are true about your network traffic?

A. You will not be able to view the data in the packets, as it is encrypted.
B. You will not be able to identify the upper layer protocol.
C. You will be able to view the unencrypted data in the packets.
D. You will be able to identify the encryption algorithm in use.
E. You will not be able to view the packet header.

Answer: C

Question 3.
In order to perform promiscuous mode captures using the Wireshark capture tool on a Windows Server 2003 machine, what must first be installed?

A. IPv4 stack
B. IPv6 stack
C. WinPcap
D. Nothing, it will capture by default
E. At least two network adapters

Answer: C

Question 4.
You are configuring the rules on your firewall, and need to take into consideration that some clients in the network are using automatic addressing. 

What is the IP address range reserved for internal use for APIPA in Microsoft networks?

A. 169.254.0.0 /4
B. 169.254.0.0 /16
C. 169.254.0.0 /8
D. 169.254.0.0 /0
E. 168.255.0.0 /16

Answer: B

Question 5.
If you capture an 802.11 frame, and the ToDS bit is set to zero and the FromDS bit is set to zero, what type of WLAN is this frame a part of?

A. Mesh
B. Broadcast
C. Infrastructure
D. Hierarchical
E. Ad Hoc

Answer: E

Question 6.
There are several options available to you for your new wireless networking technologies, and you are examining how different systems function. 

What transmission system uses short bursts combined together as a channel?

A. Frequency Hopping Spread Spectrum (FHSS)
B. Direct Sequence Spread Spectrum (DSSS)
C. LamarAnthell Transmission (LAT)
D. Digital Band Hopping (DBH)
E. Digital Channel Hopping (DCH)

Answer: A

Question 7.
You have just installed a new Intrusion Detection System in your network. You are concerned that there are functions this system will not be able to perform. 

What is a reason an IDS cannot manage hardware failures?

A. The IDS can only manage RAID 5 failures.
B. The IDS cannot be programmed to receive SNMP alert messages.
C. The IDS cannot be programmed to receive SNMP trap messages.
D. The IDS cannot be programmed to respond to hardware failures.
E. The IDS can only inform you that an event happened.

Answer: E

Question 8.
For the new Snort rules you are building, it will be required to have Snort examine inside the content of the packet. Which keyword is used to tell Snort to ignore a defined number of bytes before looking inside the packet for a content match?

A. Depth
B. Offset
C. Nocase
D. Flow_Control
E. Classtype

Answer: B

Question 9.
You have recently taken over the security of a mid-sized network. You are reviewing the current configuration of the IPTables firewall, and notice the following rule:
ipchains -A input -p TCP -d 0.0.0.0/0 12345 -j DENY

What is the function of this rule?

A. This rule for the output chain states that all incoming packets from any host to port 12345 are 
    To be denied.
B. This rule for the input chain states that all incoming packets from any host to port 12345 are to 
    be denied.
C. This rule for the input chain states that any TCP traffic from any address destined for any IP 
    address and to port 12345 is to be denied.
D. This rule for the output chain states that any TCP traffic from any address destined for any IP 
    address and to port 12345 is to be denied.
E. This rule for the input chain states that all TCP packets inbound from any network destined to 
    any network is to be denied for ports 1, 2, 3, 4, and 5.

Answer: C

Question 10.
At a policy meeting you have been given the task of creating the firewall policy. 

What are the two basic positions you can take when creating the policy?

A. To deny all traffic and permit only that which is required.
B. To permit only IP traffic and filter TCP traffic
C. To permit only TCP traffic and filter IP traffic
D. To permit all traffic and deny that which is required.
E. To include your internal IP address as blocked from incoming to prevent spoofing.

Answer: A, D

	Web www.certsbraindumps.com