Question 1.
Which VNX enclosures use a common motherboard architecture?

A. DME and SPE
B. DPE and SPE
C. DPE and 25-drive DAE
D. Control Station and DME

Answer: A

Explanation: 

Question 2.
What protocols does the Data Mover support?

A. CIFS, NFS, pNFS and MPFS
B. CIFS, pNFS, and SCSI
C. MPFS, HTTP, FTP, and NFS
D. NFS, FC, and CIFS

Answer: A

Explanation: 

Question 3.
What are the minimum components required to configure a VNX5500 for Block storage system?

A. Control Station, SP, DAE
B. Control Station, SP, DME
C. SP, DME, DAE
D. SPS, SPE, DAE

Answer: D

Explanation: 

Question 4.
Which kind of back-end bus connectivity is supported on a VNX storage system?

A. 4 lane 6 Gb/s SAS
B. 4 lane 6 Gb/s FC
C. 2 lane 6 Gb/s SAS
D. 2 lane 6 Gb/s FC

Answer: A

Explanation: 

Question 5.
How are SAS bus hardware IDs configured for the VNX enclosures?

A. Automatically assigned during system boot process
B. Assigned by the address switch located on each enclosure
C. Assigned by Unisphere Service Manager
D. Assigned by the Backend Bus Reset Wizard in Unisphere

Answer: A

Explanation: 

Question 6.
A customer asks your help in determining which types of DPE and disk drives are supported in a VNX storage system. How would you respond?

A. 2U DPE with either fifteen 2.5” SAS or twenty-five 3.5" EFD disk drives
B. 3U DPE with either fifteen 3.5” EFD, SAS or twenty-five 2.5" SAS disk drives
C. 4U DPE with either fifteen 3.5” FC, EFD or twenty-five .2.5" SAS disk drives
D. 3U DPE with either fifteen 2.5” EFD, FC or twenty-five 2.5” EFD disk drives

Answer: B

Explanation: 

Question 7.
Refer to the exhibit.
 

Where is DM 3 located?

A. Location 6
B. Location 5
C. Location 7
D. Location 10

Answer: A

Explanation: 

Question 8.
What IP address is assigned to the eth2 interface on a Control Station?

A. IP address for the B management network
B. IP address for the A management network
C. Public IP address for the customer's network
D. IP address for the peer Control Station

Answer: A

Explanation: 

Question 9.
What IP address is assigned to the eth3 interface on a Control Station?

A. IP address for the A management network
B. IP address for the B management network
C. Public IP address for the customer's network
D. IP address for the peer Control Station

Answer: C

Explanation: 

Question 10.
Refer to the exhibit.
 
Which component is located in location 3?

A. CS 1
B. CS 0
C. DAE 0
D. DAE 1

Answer: A

Explanation: 

	Web www.certsbraindumps.com