Question 1.
Exhibit #1:
 
Exhibit #2:
 
You work as a network administrator for ITCertKeys.com. You study the exhibits carefully.

What is the effect of executing the commands shown in the exhibit?

A. No hosts will be able to communicate with interface mgmt0
B. All hosts will be able to communicate with interface mgmt0
C. Host B will not be able to communicate with interface mgmt0
D. Host A will not be able to communicate with interface mgmt0

Answer:  D

Question 2.
What two commands must be executed on an MDS 9000 family switch in order to change a dynamically assigned Domain ID 5 to a static Domain ID 10 for VSAN 10? (Choose two.)

A. ITCertKeys2(Config)#fcdomain domain 10
B. ITCertKeys2(Config-if)#no shut fcdomain 10
C. ITCertKeys2(Config-if)#shut fcdomain 5
D. ITCertKeys2(Config)#fcdomain restart disruptive vsan 10
E. ITCertKeys2(Config)#fcdomain domain 10 static vsan 10
F. ITCertKeys2(Config)#fcdomain restart vsan 10

Answer:  D, E

Question 3.
Exhibit:
 
You have been asked to convert three existing ISLs into a PortChannel as nondisruptively as possible. 

Which approach will best accomplish this?

A. Convert the ISLs into EISL and then place them into a PortChannel
B. Ensure that the VSAN allowed lists on both ends of each link are identically configured, then create the three-link PortChannel
C. Place all three ISLs into a PortChannel, because PortChannel creation is a nondisruptive operation
D. Place one link into a single-link PortChannel and then add the other two links to the PortChannel

Answer:  D

Question 4.
The MDS 9000 family switches use what three technologies to protect against unauthorized management access? (Choose three.)

A. SNMPv3
B. WEBM
C. RMON
D. SSH
E. SES
F. RBAC

Answer:  A, D, F

Question 5.
What is the default policy when defining role-based access for a VSAN?

A. Permit only for the default VSAN
B. Deny
C. Permit
D. There is no default role policy for a VSAN

Answer:  C

Question 6.
ITCertKeys.com would like to implement a low-cost traffic engineering solution that provides a primary data path and a secondary data path that will only be used in the event of a failure in the primary path. 

Which of these solutions best meets the customer needs?

A. VSAN allowed list pruning
B. FCC
C. FSPF link costs
D. VOQ
E. QoS

Answer:  C

Question 7.
Which two of these features are characteristics of out-of-band management for the Cisco MDS 9000 Series switches? (Choose two.)

A. Configure during the initial switch setup
B. FCIP
C. 10/100/1000 Ethernet connection
D. Logical interface VSAN 1
E. CUP Management of the switch for FICON
F. IPFC

Answer:  A, C

Question 8.
Which three of these terms are valid Fibre Channel topologies? (Choose three.)

A. Arbitrated loop
B. Point-To-Point
C. Gigabit Ethernet
D. Switched backbone
E. Switched fabric
F. Autonomous region

Answer:  A, B, E

Question 9.
Which three options allow or enable nondisruptive upgrades? (Choose three.)

A. Installing a license
B. IPS module software upgrades
C. Using the install-all command
D. Upgrading the loader
E. Dual supervisor modules on a Cisco MDS 95000 Series switch
F. Using the reload command

Answer:  A, C, E

Question 10.
DRAG DROP
You work as a network technician at ITCertKeys.com. Your boss Mrs. ITCertKeys, is interested in compression modes. Match the appropriate mode with the correct bandwidth.
 
Answer:
 

	Web www.certsbraindumps.com