Question 1.
A NetBackup administrator receives Status Code 58 “can’t connect to client” every time there is a backup attempt of the client named “alpha.”

Which command will help determine if the NetBackup client service is listening?

A. telnet alpha
B. bpcd ping alpha
C. telnet alpha bpcd
D. bpclntcmd -ping alpha

Answer: C

Question 2.
Which command is used to verify that NetBackup and Media Manager daemons are running?

A. bpps-a
B. bpdbm-a
C. bpbackup-a
D. bpprocess-a

Answer: A

Question 3.
A backup of a client failed with “Status 213: no Storage Units available for use.” The client is in a policy that is directed toward Any Available Storage Unit.

What are two possible reasons for Status Code 213? (Choose two.)

A. All drives are down
B. The master server is offline.
C. There are no media in the robot.
D. Storage Units are set to “On Demand Only”.

Answer: A, D

Question 4.
A job fails with “Status Code 96: unable to allocate new media.”

Which two can cause this error? (Choose two.)

A. The tape device is down.
B. The Robot is incorrectly defined.
C. The media server is online.
D. The density of available media is invalid
E. The scratch pool has no media

Answer: D, E

Question 5.
After installing NetBackup client software on a new client, attempted backups fail with a status ode indicating that NetBackup cannot communicate with the client.

What are two ways to pinpoint the source of the problem? (Choose two.)

A. verify that the NetBackup client is listening
B. verify that the bptm process is running on the client.
C. check the bprd log to verify that the backup has initiated.
D. enable the bpcd log on the client to see if the media server is binding to a port.

Answer: A, D

Question 6.
You receive “Status Code 1: the requested operation was partially successful.”

Which two do you perform to analyze this result? (Choose two.)

A. reviewing the bpcd log file on the master or media server
B. reviewing the Progress log on a Database Option client
C. executing the bpclntcmd command from the failed client
D. checking the All Log Entries under Reports for the failed client

Answer: B, D

Question 7.
Which command is used to install NetBackup on a UNIX client where rsh is NOT available?

A. bpcd_install
B. update_clients
C. bpclient_install
D. install_client_files

Answer: D

Question 8.
You have just installed a NetBackup 5.0 master server.

Which three NetBackup processes are running if the installation was successful? (Choose three.)

A. bprd
B. bptm
C. bpjobd
D. bpdbm
E. bpdm

Answer: A, C, D

Question 9.
You enabled Multiple Data Steams for a policy. Which list backs up local volumes C:D: and E: using two streams?

A. ALL_LOCAL_DRIVES
B. C:\
    D:\
    NEW_STREAM
    E:\
C. NEW_STREAM
    C:\
    NEW_STREAM
    E:\
D. NEW_STREAM
    ALL_LOCAL_DRIVES
    NEW STREAM

Answer: C

Question 10.
Where in the NetBackup Administration Console do you create a disk location for backups?

A. Policy
B. Storage Units
C. Host Properties
D. Device Manager

Answer: B

	Web www.certsbraindumps.com