|
Question 1.
To enable the Automatic HTTP Proxy Service for guest users, you must define proxy server addresses for _______.
A. the "Guest Access" Access Policy
B. each 720wl that will support guest users
C. each Connection Profile that will support guest users
D. every component of the 700wl system
Answer: B
Question 2.
The full-edge deployment of the 700wl system provides for greater flexibility in policy definition than the single-gateway solution. This is because _______.
A. multiple 740wl Access Control Servers manage each 720wl
B. each 720wl is connected directly to a 740wl
C. each 720wl downlink port supports a single wireless access point
D. each wireless access point is defined as a virtual location
Answer: C
Question 3.
The single-gateway design for a 700wl system is suitable for smaller networks because it _______.
A. does not require any configuration of network switches
B. requires fewer 700wl devices than the full-edge solution
C. enables more granular policies than the full-edge solution
D. does not require the use of VLANs and virtualized locations
Answer: B
Question 4.
You are designing a 700wl system for deployment at a landscaping and facility-maintenance firm.
Which circumstance could require the use of virtualized locations?
A. Users associated with the "Designers" Identity Profile must access the 700wl system from
multiple locations.
B. One 720wl downlink port must support the "Maintenance" Connection Profile and the "Design"
Connection Profile.
C. The system must support redundant 740wl Access Control Servers located in different
subnets.
D. Designers must use LDAP authentication, and maintenance personnel must use RADIUS
authentication.
Answer: B
Question 5.
What are the components of a 700wl Rights Assignment? (Choose three)
A. User Profile
B. Identity Profile
C. Connection Profile
D. Security Policy
E. Group Policy
F. Access Policy
Answer: B, C, F
Question 6.
Under what circumstances does the HP Pro Curve Access Control Server 740wl forward user traffic to the secure network?
The 740wl ___________.
A. forwards user traffic during roaming
B. forwards user traffic if an Access Controller fails
C. never forwards user traffic
D. forwards user traffic until the user is authenticated
Answer: C
Question 7.
A 720wl's default downlink IP address is ________.
A. used as the default gateway for all clients
B. used by the 740wl to communicate with the 720wl
C. dictated by the 740wl for all 720wls in a 700wl system
D. the address to which NAT clients' source addresses translated
Answer: C
Question 8.
At approximately 7:30 p.m., a user complains that she cannot access her mail server from a conference room. She claims she was able to access the mail server earlier in the day from her desk.
What system tool is most useful for troubleshooting this user's network access problem?
A. Client Status page
B. User Rights Simulator
C. LDAP Transaction Tracer
D. RADIUS Transaction Tracer
Answer: B
Question 9.
At a customer site, all guest users who log on through the 700wl system can access the customer's intranet servers. To improve security, you configure a Redirected Traffic Filter so that guests, who attempt to access intranet resources, will be redirected to a Web page displaying guest access rules.
When testing the filter, you see that guest users actually receive a "Page not available" error when attempting to access these resources. To troubleshoot this problem, you should make sure you _______.
A. disabled all default Redirected Traffic Filters to ensure they do not conflict with your custom
filter
B. configured an Authentication Policy and logon procedure for all guest users
C. associated the new Redirected Traffic Filter with the Access Policy that affects guests
D. configured an Allowed Traffic Filter to specify the destination of the redirected traffic
Answer: D
Question 10.
You are troubleshooting an HP Pro Curve Integrated Access Manager 760wl that is not reachable through the web or Telnet.
Which information about the device's configuration can be gathered from the LCD panel on the device's front panel?
Select TWO.
A. system time
B. system uptime
C. IP addressing information
D. number of transmitted packets
E. installed software version
Answer: C, E
Question 11.
At a customer site, you are configuring an HP ProCurve Access Control Server 740wl.
Which tasks can be performed at the CLI? Select TWO.
A. configure IP address
B. configure a connected 720wl
C. set administrative password
D. add users to built-in database
E. configure LDAP authentication
Answer: A, C
Question 12.
You are configuring a 740wl at a customer site. To set the shared secret without echoing it to the console, you must enter set shared secret with _____________
A. the no echo parameter
B. the shared secret as a parameter
C. no parameters
D. the administrative password
Answer: C
Question 13.
You must configure a 720wl that has not received an IP address through DHCP.
How can you configure an IP address for this system?
A. Use the Administrative Console to locate the 740wl by its MAC address and select it from the
list of available devices.
B. Start a web browser session using the default IP address 42.0.0.1.
C. Start a web browser session using the factory-assigned IP address of the uplink port.
D. Start a Telnet session with the default IP address 42.0.0.1.
E. Start a direct serial console session and configure the device's IP address at the CLI.
Answer: E
Question 14.
Which statement is true about the date and time configuration of the 700wl devices?
A. Time settings must be dynamically acquired or statically defined each time the 740wl is
rebooted.
B. The 740wl can be configured to obtain time services from an NTP server.
C. The 740wl and each 720wl cannot be configured to obtain time services from different servers.
D. The 720wl acquires its time settings from the 740wl.
Answer: B
Question 15.
When organizing 720wl Access Controllers into folders in the Administrative Console, you cannot _______.
A. place more than five devices in a folder
B. create folders within folders
C. create custom folders
D. configure more than five folders
Answer: B
Question 16.
Which statement is true regarding this naming convention?
740wl-760wl-dist-4.1.1.37. The file ________.
A. is invalid because the filename has no extension
B. is designated for use in local updates
C. must be compiled before installation
D. must be accompanied by a checksum file
Answer: B
Question 17.
The administrator of a 700wl system is performing a remote update on multiple 720wl devices. To simplify this task, the administrator changes the names of the image and checksum files. The administrator is careful to not change the file extensions. The update will ________.
A. fail on devices currently running version 3 software
B. succeed for all devices
C. fail for all devices
D. fail if it is not performed at the CLI
Answer: C
|
New Collection: thanks to itcertkeys
Copyright © 2004 CertsBraindumps.com Inc. All rights reserved.