|
Question 1.
The Switch 7700 or Switch 8800 can be used as the primary authentication service or as a backup if the RADIUS server group is unavailable.
A. True
B. False
Answer: A
Question 2.
Which four are Switching Fabric features/Functions on the Switch 8800? (Choose four)
A. Each Switch Fabric has a data channel to every module
B. Supports a hot-swappable, load-balancing Switch Fabric.
C. There is a data channel between the two Switch Fabrics.
D. Each Switch Fabric has a management channel to every module
E. Supports a hot-standby, hot-swappable redundant Switch Fabric
F. The master Switch Fabric is always set to slot #1 unless the fabric in slot #1 fails
G. The master Switch Fabric provides route calculation and management for the entire chassis
Answer: A, B, C, E
Question 3.
What is the maximum number of Linux Aggregation load-balancing groups supported on the Switch 7700?
A. 4 groups
B. 13 groups
C. 24 groups
D. 64 groups
E. 128 groups
Answer: D
Question 4.
Which three are Quality of Service (QoS) features/functions on the Switch 8800?
(Choose three)
A. Has eight output queues per port
B. Supports Differentiated Services (Diff Serv) prioritization
C. Uses a Random Early Detection (RED) queue prioritization
D. Uses a Weighted Random Early Detection (WRED) queue prioritization
E. Can configure the priority queues "globally" across all I/O interfaces on a switch
F. Uses Resource Reservation Protocol (RSVP) to allocate bandwidth for high-priority
applications
Answer: A, B, D
Question 5.
Which two rules must be followed when configuring Link Aggregation groups on the Switch 7700 1000BASE-T and 1000BASE-X modules? (Choose two)
A. The Linux Aggregation group can start on any port.
B. All the ports in a Link Aggregation group must be consecutive
C. A single Link Aggregation group can span multiple Interface Modules
D. A maximum of eight ports can belong to a single Link Aggregation group
E. A maximum of twelve ports can belong to a single Link Aggregation roup
Answer: A, B
Question 6.
Exhibit:
Which three Ethernet modes are supported on the Switch 7700 8-port 1000BASE-T(3c16859)Interface Module? (Choose three)
A. 10 Mbps in full duplex only
B. 10 Mbps in half/full duplex mode
C. 100 Mbps in full duplex mode only
D. 100 Mbps in half/full duplex mode
E. 1000 Mbps in full duplex mode only
F. 1000 Mbps in half/full duplex mode
Answer: B, D, E
Question 7.
Which two are functions of Switch 40x0 Family Multinetting? (Choose two)
A. Automatically assigns multiple VLANs on each router interface
B. Floods traffic from different subnets on the same broadcast domain
C. Enables configuration of multiple router interfaces for each VLan/broadcast domain
D. Enables multiple VLANs/broadcast domains to be configured for each router interface
Answer: B, C
Question 8.
What is the benefit of using the Switch 40x0 Family's Spanning Tree Ignore/Disable feature?
A. Prevents disassociation of Layer 2 traffic from Layer 3 traffic.
B. Enables use of a routing protocol at Layer 2 to make forwarding decisions
C. Enables use of spanning Tree Protocol (STP) at Layer 3 to prevent loops in the network
D. Supports use of routing paths at Layer 3, while Spanning Tree Protocol (STP) manages Layer
2 switched links
Answer: D
Question 9.
Which three are security-design features that can be employed in enterprise networks to improve security? (Choose three)
A. Enable IEEE 802 d link aggregation
B. Turn off IGMP snooping on all access-layer switches
C. Provide security for active devices using local or RADIUS authentication
D. Support IEEE 802.1X Network Login for authentication and authorization
E. Provide separate VLANs for management and wireless users with a VLAN-centric design
F. Employee TCP Windowing and or IEEE802.3X Flow Control to minimize effects of network
attacks
Answer: C, D, E
Question 10.
Which three are key requirements for the Access Layer (edge) of the network?
(Choose three)
A. Multilayer traffic prioritization
B. Multiple priority queues per port
C. Hardware-based Access Control List (ACLs)
D. Rate limiting and remarking for outgoing traffic.
E. MAC address authorization or IEEE 802.1X Network Login
F. Resource Reservation Protocol (RSVP) bandwidth allocation
Answer: A, B, E
Question 11.
Which three are true statements regarding 10 Gigabit technology and/or 3Com products? (Choose three)
A. The 3 Com XFP 10G Fiber Transceivers use LC connects
B. IEEE 802.3X defines the 10GBASE-CX4 standard for Twin axial
C. 3Com supports 10G interface Modules for both the Switch 7700 and Switch 8800
D. The 10GBASE-T standard requires four-pair Category 5 or two-pair Category 6 UTP wiring
Answer: A, B, C
Question 12.
Which three are recommended guidelines for an XRN network? (Choose three)
A. Only enable Rapid Spanning Tree Protocol (RSTP) or Spanning Tree Protocol (STP) on edge
switches
B. Do not insert Fabric interconnect Modules into the Super Stack 3 Switch 4900 or Switch 40x0
switches
C. Run the same version of the Gigabit Multilayer Switching (MS) Software (4Xor higher) across
the fabric
D. Use fault-tolerant 3Comhardware, i.e the Switch 40x0 family that provides additional levels of
hardware fault tolerance
E. The XRN Fabric Modules should be installed while the fabric switch powered on. Hot swapping
XRN Fabric Modules is also recommended in the event of a failure
Answer: B, C, D
Question 13.
Which three are benefits/features of the 3Com XRN technology? (Choose three)
A. Ensure continuous network availability
B. Supports enhanced network performance
C. Can be created using any IP-based switch
D. Create a path for future-proofing the network
E. Eliminates the need for hardware redundancy to achieve maximum network resiliency
Answer: A, B, D
|
Question 1.
An account manager is meeting with a customer who is interested in a Cisco IP Communications solution. The customer needs to support a variety of analog devices, voice mail, auto attendant, and 200 users.
Which solution should the account manager discuss with this customer?
A. a full Cisco CallManager solution
B. a full Cisco CallManager solution with Cisco Unity
C. Cisco CallManager Express
D. Cisco CallManager Express with Cisco Unity Express
Answer: D
Question 2.
One of your potential customers has concerns about choosing a Cisco IP Communications solution because, according to the competition, IP telephony solutions cost more than they are worth.
Which strategy would be most appropriate to defuse this concern?
A. Unlike traditional office environments where voice and data are separate, Cisco IP
Communications supports the idea of a converged network where the telephony and IP
components are integrated.
B. An IP-enabled PBX inevitably reaches a point called the golden phone, at which an addition
requires more than just a phone. In fact, it requires a card to support the phone, and possibly a
new shelf of a cabinet to house the card. These upgrades end up being very costly and offer
the customer no flexibility to implement nonproprietary solutions in the future.
C. With low operating and capital costs, a Cisco IP Communications deployment will pay for itself
in 18 months on average and will provide an average annual savings per user of US$334. The
drivers of the ROI are determined by the unique network circumstances of the customer, such
as the speed of migration, the remaining life on the PBX, and the extent of the data upgrade.
D. Cisco IP Communications solutions are based on tested and verified designs that ensure rapid
ROI. Cisco or its IP telephony specialized channel partners can also customize these solutions
to meet business demands and realize cost savings resulting from existing equipment or
applications.
Answer: C
Question 3.
Organizations that embrace Cisco IP Communications solutions are able to interoperate with existing TDM systems and applications, as well as support which two traditional telephony networking standards? (Choose two.)
A. QSIG
B. BGP
C. SIP
D. TDM
E. DPNSS
Answer: A, E
Question 4.
The IT manager from a prospective client organization explains that their network is overloaded. The network has been in use since 2002 with minimal upgrades, and is composed of several different devices from different vendors. E.mail is slow, the voice.mail system is outdated, and employee productivity and responsiveness are suffering.
Given this scenario, which business driver is most appropriate to sell a Cisco IP Communications solution?
A. reduce operating costs
B. increase revenue generation
C. facilitate future expansion
D. reduce the number of employees
Answer: A
Question 5.
You require an easy-to-use, web.enabled tool to demonstrate to a prospective customer the benefits of a converged network in terms of productivity enhancements and real estate savings.
Which tool should you use?
A. Cisco ROI analysis
B. Cisco CNIC
C. business case from the industry of the prospect
D. customized hurdle rate analysis
Answer: B
Question 6.
An account manager is meeting with a service provider that has installed Cisco CallManager Express at a large number of its subscriber sites. The customer wants to maintain and troubleshoot Cisco CallManager Express remotely.
Which Cisco CallManager Express feature makes this possible?
A. CiscoWorks VPN/Security Management Solution
B. Cisco Network Analysis Module
C. commanD.line interface
D. CiscoWorks IP Telephony Environment Monitor
Answer: C
Question 7.
Which two baseline discovery questions would be most appropriate to ask an IT manager? (Choose two.)
A. in how many locations do you have Cisco routers deployed?
B. Would installing Cisco IP Communications Express with other business systems reduce the
complexity of your IP infrastructure?
C. How many platforms do you intend to use for call processing and voice mail?
D. Do you anticipate growth in the number of employees over the next few years?
Answer: A, C
Question 8.
A potential customer has several global offices, including one in North America, two in France, and one in Germany. This prospect is investigating cost-effective voice mail and auto attendant, and has asked for your recommendation.
What application would best meet the needs of the customer?
A. Cisco Unity Express
B. Cisco Unity
C. customized XML applications
D. Cisco CallManager
Answer: A
Question 9.
How does a converged solution work?
A. Voice traffic is carried over a circuit-switched network, and data traffic is carried on an IP
network
B. Voice, video, and data are integrated onto a single IP network.
C. The network is comprised of proprietary timE.division multiplexing hardware and circuits.
D. The LAN is used for data traffic, and the WAN is used to integrate voice and video traffic
Answer: B
Question 10.
You work as the network administrator at Certpaper.com. Certpaper has several global offices, including one in Britain, two in North America, and three in Asia. The company needs to investigate cost-effective voice mail and auto attendant, and has asked for your recommendation.
What application would best meet the requirements of the company?
A. Cisco Unity Express
B. Customized XML applications
C. Cisco Unified Communications Manager
D. Cisco Unified CallConnector Mobility
Answer: A
Copyright © 2004 CertsBraindumps.com Inc. All rights reserved.