Question 1.
What IE is not mandatory in a Q.931 Service msg?

A. Bearer capability
B. Channel ID
C. Message Type
D. Change Status
E. Call Reference

Answer: A

Question 2.
The purpose of Administrative Distance, as used by Cisco routers, is:

A. To choose between routes from different routing protocols when receiving updates for the 
   Same network
B. To identify which routing protocol forwarded the update
C. To define the distance to the destination used in deciding the best path
D. To be used only for administrative purposes

Answer: A

Question 3.
What is the maximum PMD value of a 100km fiber segment if the cable is specified with 0.5ps/km? (worst case)?

A. 0.005ps
B. .05ps
C. 5ps
D. 50ps
E. 500ps

Answer: C

Question 4.
What is the equivalent of 50 GHz spacing in DWDM in terms of nm?

A. 1.6 nm
B. 0.8 nm
C. 0.4 nm
D. 0.2 nm

Answer: C

Question 5.
Click the Exhibit to view the topology.
 

Router A has a 512K-access port into the frame relay cloud. Router B has 128K-access port into the frame relay cloud. The two routers are connected with symmetrical PVCs that are configured for 64K committed information rate (CIR). What Frame Relay Traffic Shaping map-class subcommand should be entered on Router A to prevent workstation A from overrunning the access port on Router B?

A. frame-relay traffic-rate 128000 512000
B. frame-relay traffic-rate 64000 512000
C. frame-relay traffic-rate 512000 64000
D. frame-relay traffic-rate 128000 64000
E. frame-relay traffic-rate 64000 128000

Answer: E

Question 6.
If a host sends a TCP segment with the RST flag set, it means:

A. The receiver should send all data in the reassembly buffer to the application receiving it 
    immediately.
B. The receiver should reset the session.
C. Any routers between the source and destination hosts should reset the state of the connection 
   in their buffers.
D. The receiver should make certain its send buffer is pushed onto the wire.

Answer: B

Question 7.
How many E1 channels can STM-1 frame transport?

A. 7
B. 21
C. 63
D. 84

Answer: C

Question 8.
BGP can implement a policy of 'Route Dampening' to control route instability. 

What statement about route dampening is NOT correct?

A. A numeric penalty is applied to a route each time it flaps.
B. The penalty is exponentially decayed according to parameters, such as halF. life-time.
C. The history of unstable routes is forwarded back to the sender to control future updates.
D. The route is eventually suppressed based on a configurable 'suppress limit'.

Answer: C

Question 9.
MPLS traffic engineering data is carried by:

A. Opaque LSAs or IS-IS TLVs
B. BGPMEDs
C. RTP or RTCP packets
D. MBGP

Answer: A

Question 10.
Click the Exhibit button.
 

In the diagram, if a resilient packet ring (RPR) is built between ML-series cards,____restoration exists on the ring, while the redundant connections to the 7609 rely on protection.

A. 50ms,STP
B. STP.STP
C. STP, 1+1 APS
D. 50ms, 50ms

Answer: A

	Web www.certsbraindumps.com